Model: PCDTHR-150 (TRACTOR)
TRACTOR MOUNTED CORE DRILLING RIG : https://youtu.be/ZgXwJR-TY5c
Technical Specifications:
Capacity:
Core drilling NW/NQ depth Rotary drilling Drilling diameter Drilling depth DTH drilling Drilling diameter Drilling depth |
150m.
170mm 150 m.
114 mm 150 m. |
Carrier
Make GVW Model Engine Rating |
Ø Tractor 4 Wheel drive (Optional: 2 wheel Drive)
New Holland of any equivalent Make & Model 7 Tones 7500 – 4 Wheel drive 75 HP @ 2200 Rpm
|
Prime Mover | The same Tractor engine through suitable Power Take Off shall power the hydraulic system.
|
Mounting Structure | Electrically welded steel structure fitted to the Tractor body.
|
Mast Assembly
Mast overall Length Rotary Head travel |
Sturdy structural channel structure electrically welded. Mast dumping will be provided for angle drilling
6000mm 4500mm Ø Mast raising and lowering by double acting hydraulic cylinder
|
Feed System
Cylinder size Pull Back Pull Down Hoisting speed |
Feed & Hoist actuation: Pulley, wire rope & Hydraulic cylinder.
100x70x1525 4700 Kgf 2400 Kgf (UP) 39Mtr/ Minute
Ø Having adequate travel to handle drill pies and casing pipes up to 3 Mtr. Long. Ø Feed system consists of Hold back arrangement to control limit weight on bit, rapid and slow feed arrangement to suit variable ground condition.
|
Rotary Head
|
Stage –1 Stage-2
Out put speed: 0-600 RPM 0-120 RPM Out put Torque: 40 Kg-M 200 Kg-M Rotary head will be provided with swing out.
|
Hydraulics
Max operating pressure Hydraulic Tank capacity Filtration (Nom) – Return line |
Ø The entire Equipment is designed to operate at high temperature encountered in the normal weather conditions.
Ø Open loop circuit with variable/Fixed displacement piston pumps and proportional valves for feed and rotation. Diverter valves for auxiliary drives.
180 Kg/Cm2 200 Liters. 10/25 Microns
|
Control Panel | All Necessary control and monitoring valves and gauges are installed at control panel located nearer to drilling point for driller convenience
|
Stabilizer
Cylinder bore/ Stroke No. Of Jacks |
Hydraulically operated
100mm/610mm 4 Nos.
|
Breakout wrench
Size
|
The drill Rig is equipped with double acting cylinder for drill rod makeup and breakup
80x40x300
|
Water Injection Pump
Capacity |
Hydraulically operated triplex water injection pump,
80 Liter/minute and 40bar
|
Wire line Winch
|
Hydraulically operated wire line winch required for incase of wire line (Q’ series) drilling
|
Cetrifugal Pump
Max. Flow Max. Pressure |
Hydraulically operated centrifugal pumpis used for mud rotary drilling,
600 lpm 8bar
|
Air compressor
Air delivery Pressure Make |
Air compressor will be mounted on Separate four wheel trolley with two axles.
600 cfm 200 psi Atlas copco/ Elgi |
Air line lubricator
Capacity Make |
Line oiler is used for DTH hammer lubrication.
600 cfm-200 psi Spinc |